Why it matters
Trip counts, distances and route comparisons are only useful if each trip matches a real journey. Fixing the few that don’t keeps your stats and your mileage log right.
Merge trips.
Join trips that belong together, such as a road trip broken up by stops. Open the Trips tab, tap More → Merge Trips and pick them.
- 2 to 10 trips at once
- Trips must be for the same vehicle and must not overlap
- Spanning up to 30 days in total
- The merged trip is marked Merged; the originals are replaced
Split a trip.
Divide a trip that ran two journeys together. Open the trip and tap More → Split Trip.
- Up to 10 pieces
- Place split points on the route or with the slider
- Or tap Split at recording breaks to cut wherever recording paused
- The name, note and videos stay with the first piece
Trim the ends.
Remove the part where you walked to the car or sat in the drive. Open the trip and tap More → Trim Trip.
- Trim the start, the end or both
- Distance, time and speeds are recalculated
- Available on trips that weren’t merged
Questions about Merge, split and trim trips
Why did one drive get recorded as two trips?
Usually because recording stopped during a stop, for example when an automation ran Stop Trip or a trip ended after being idle. Merge the two in the Trips tab with More → Merge Trips. To keep it from happening, pause on stops instead of stopping, and resume with Start or Resume Trip.
Can I undo a merge?
No. Merging replaces the original trips with the merged one. You can split the merged trip again if you need to.
Can I split a trip into more than two parts?
Yes, into up to 10 pieces. Place the points yourself or tap Split at recording breaks to cut wherever recording paused for 10 seconds or more.
When should I use "Start Trip" vs "Start or Resume Trip"?
Use Start or Resume Trip when stops should stay part of one trip, and Start Trip when each journey should be its own record. Full answer
How do I automatically pause or end trips?
Turn on Auto-pause When Stationary and Auto-End Trips in Settings → Driving, or pair each start automation with a Pause Trip automation on disconnect. Full answer
Works well with
Last updated
